================================================================================
                                样例使用说明
                             Sample Description
================================================================================
功能描述：
此样例演示了使用TIM1输出三路频率为10Hz占空比分别为25%、50%、75%的PWM波形以及他们
的互补信号，并实现了250ns的死区和刹车功能。

Function descriptions:
This sample demonstrates the generation of three PWM waveforms with 
frequencies of 10Hz and duty cycles of 25%, 50%, and 75% using TIM1. 
It also generates their complementary signals. It also generates their 
complementary signals and implements a 250ns dead-time and brake function.
================================================================================
测试环境：
测试用板：PY32F403_STK
MDK版本： 5.28
IAR版本： 9.20
GCC 版本：GNU Arm Embedded Toolchain 10.3-2021.10

Test environment:
Test board: PY32F403_STK
MDK Version: 5.28
IAR Version: 9.20
GCC Version: GNU Arm Embedded Toolchain 10.3-2021.10
================================================================================
使用步骤：
1. 编译下载程序到MCU，并运行
2. 将PB12引脚接低电平。
3. 使用逻辑分析仪观察引脚PA8/PA9/PA10/PB13/PB14/PB15的波形；
4. 将PB12引脚接高电平，PWM停止输出。

Example execution steps:
1.Compile and download the program to the MCU, and then run it.
2.Set pin PB12 to the low logic level.
3.Use a logic analyzer to observe the waveforms on pins PA8/PA9/PA10/PB13/PB14/PB15.
4.Set pin PB12 to a high logic level to stop PWM output.
================================================================================
注意事项：
如果需要使用按键:
StartKit版本为V2.0以下,需将StartKit.h中的StartKitVersion 2 注释掉，并打开
StartKitVersion 1
StartKit版本为V2.0及以上版本,则无需操作
PA8  -> CH1  占空比：25%
PA9  -> CH2  占空比：50%
PA10 -> CH3  占空比：75%
PB13  -> CH1N
PB14  -> CH2N
PB15  -> CH3N

Notes:
If you need to use buttons:
StartKit version is below V2.0, you need to comment StartKitVersion 2 in
StartKit.h, and open StartKitVersion 1 
StartKit version is V2.0 and above, no operation is required
PA8 -> CH1 Duty cycle: 25%
PA9 -> CH2 Duty cycle: 50%
PA10 -> CH3 Duty cycle: 75%
PB13 -> CH1N
PB14 -> CH2N
PB15 -> CH3N
================================================================================