================================================================================
                                样例使用说明
                             Sample Description
================================================================================
功能描述：
此样例配置系统时钟为PLL，并通过MCO（PA08）引脚输出，PLL的输入时钟源选择HSE。

Function descriptions:
This sample configures the system clock to use the PLL (Phase-Locked Loop) 
clock source with HSE (High-Speed External) as the input clock source and 
outputs it through the MCO (PA08) pin. The PLL frequency is configured to 
be 144MHz.

================================================================================
测试环境：
测试用板：PY32F403_STK
MDK版本：5.28
IAR版本：9.20
GCC版本：GNU Arm Embedded Toolchain 10.3-2021.10

Test environment:
Test board: PY32F403_STK
MDK Version: 5.28
IAR Version: 9.20
GCC Version: GNU Arm Embedded Toolchain 10.3-2021.10

================================================================================
使用步骤：
1. 编译下载程序到MCU，并运行；
2. 按下用户按键；
3. 使用示波器监测PA08引脚上的频率，观察是否与配置的PLL频率（144MHz）一致；

Example execution steps:
1. Compile and download the program to the MCU and run it;
2. Press the user button;
3. Use an oscilloscope to monitor the frequency on the PA08 pin and check if 
it matches the configured PLL frequency (144MHz).

================================================================================
注意事项：
如果需要使用按键:
StartKit版本为V2.0以下,需将StartKit.h中的StartKitVersion 2 注释掉，并打开
StartKitVersion 1
StartKit版本为V2.0及以上版本,则无需操作

Notes:
If you need to use buttons:
StartKit version is below V2.0, you need to comment StartKitVersion 2 in
StartKit.h, and open StartKitVersion 1 
StartKit version is V2.0 and above, no operation is required

================================================================================
