================================================================================
                                样例使用说明
                             Sample Description
================================================================================
功能描述：
此样例演示了GPIO输出模式，配置LED引脚为数字输出模式，并且每隔250ms翻转一次LED引
脚电平。运行程序后，可以看到LED灯以2Hz的频率闪烁。

Function descriptions:
This sample demonstrates the GPIO output mode. It configures the LED pin as a 
digital output mode and toggles the LED pin level every 250ms. After running 
the program, you can observe the LED blinking at a frequency of 2Hz.

================================================================================
测试环境：
测试用板：PY32F403_STK
MDK版本：5.28
IAR版本：9.20
GCC版本：GNU Arm Embedded Toolchain 10.3-2021.10

Test environment:
Test board: PY32F403_STK
MDK Version: 5.28
IAR Version: 9.20
GCC Version: GNU Arm Embedded Toolchain 10.3-2021.10

================================================================================
使用步骤：
1. 编译下载程序到MCU，并运行；
2. 可观察到STK板上的LED以2Hz的频率闪烁。

Example execution steps:
1. Compile and download the program to the MCU and run it;
2. Observe the LED on the STK board blinking at a frequency of 2Hz.

================================================================================
注意事项：
如果需要使用按键:
StartKit版本为V2.0以下,需将StartKit.h中的StartKitVersion 2 注释掉，并打开
StartKitVersion 1
StartKit版本为V2.0及以上版本,则无需操作

Notes:
If you need to use buttons:
StartKit version is below V2.0, you need to comment StartKitVersion 2 in
StartKit.h, and open StartKitVersion 1 
StartKit version is V2.0 and above, no operation is required

================================================================================
